Connecting Data And Power - Philips VARILITE VL1100 LED User Manual

Connecting Data and Power

A maximum of 32 luminaires may be connected in any one DMX data link.
Note: This maximum limit applies to the luminaire "daisy chain" only. Your system or console may
require fewer luminaires on a single data link path. Consult your console documentation for more
information.
To connect power and data:
Step 1. Connect data cable from console to first luminaire in chain at DATA IN connector.
Step 2. If required, connect additional data cables from DATA THRU connectors to DATA IN
connectors of remaining luminaires in link.
Step 3. At last luminaire in link, install male termination connector at DATA THRU connector.
(Luminaires and other devices on the same DMX chain may not function properly without
termination.)
Data In
Step 4. Connect AC Input Cable connector to power input source.
Step 5. Dress cables and secure them so that they will not interfere with luminaire head and yoke
movement.
02.16 02.000 2
I
NSTALLATION
AC In
Data Thru
VL1100 LED™ Luminaire Channel Requirements*
DMX512 Channels
19 Channels
21 Channels
27 Channels
29 Channels
*As set by the luminaire's menu system.
Figure 2-5: Data Connection
13 J un e 20 17
: I P
NSTALLATION ROCEDURES
AC In
Data Thru
Description
LED I / LED HP I Classic DMX Map
LED I / LED HP I Enhanced DMX Map
LED S / LED HP S Classic DMX Map
LED S / LED HP S Enhanced DMX Map
**DMX terminator required for last fixture on DMX line.
2
AC In
Termination**
19