Self Tests; Running Parameter Tests - Philips VARILITE VL1100 LED User Manual

Self Tests

Running Parameter Tests

The luminaire is capable of running self tests by using the TEST menu functions.
Note: If a DMX data stream is present on the luminaire's DMX input connector, Self Test and Manual
control is overwritten by the DMX command protocol and neither (Self Test and Manual) will operate.
When running tests on multiple luminaires, a loopback connector is required at the master luminaire
(first in link) and a male termination connector is required at the last luminaire in the link. Refer to
page 11 for more information regarding the construction of these connectors.
Note: After 10 seconds of inactivity, the menu display will change to the default state showing the
address.
To connect luminaires for simultaneous testing:
Step 1. At first luminaire in link, install loopback connector into DATA IN XLR connector.
Step 2. At last luminaire, install DMX termination connector into DATA THRU XLR connector.
Step 3. At master luminaire Menu Display, press [Menu].
First luminaire containing
software version to download
Loopback Connector
To run tests:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Test appears. Press [Enter].
Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to
Chart" on page 55
Step 4. Press [Enter] to run test.
Step 5. Press [Menu] to stop test at any time.
02.16 02.000 2
Luminaire 1
requiring update
Data Thru
Figure 4-2: Hardware Setup
for a complete list of test parameters which can be chosen.
13 J un e 20 17
M S : S
ENU YSTEM ELF
Luminaire 2
requiring update
Data Thru
DMX Termination Connector
"Menu System Function
4
T
ESTS
61