Western Digital WD Caviar Installation Manual page 32

EZ-Drive. You must install Windows before running the setup
program.
The 32-bit disk access driver is a Windows 3.1x driver; it is
NOT intended for use in Windows NT and Windows 95 as
these operating systems have built-in 32-bit disk access support.
To Run the Setup Program
1. Insert the EZ-Drive disk into drive A (or B). You must run
the setup program from Windows. In Windows, select Run
from the File Menu. Type: a:\setup
2. The EZ-Drive installation utility loads. Select Install Driver
from the options listed at the bottom of the screen.
When the screen prompt "Restart Windows" displays, your
driver is installed.
3. Select Restart Windows.
4. A Status Screen displays hard drive information the first time
you reboot. Press any key to start Windows.
Your driver is now installed. Use the following instructions to
enable the 32-bit disk access driver.
To Enable the 32-bit Disk Access Driver
1. Start Windows. Select Control Panel, and then select 386
Enhanced.
2. Select Virtual Memory, and then select Change.
3. Select Use 32-Bit Disk Access at the bottom of the screen.
Select OK.
28 EZ-Drive Software Installation