Western Digital WD Caviar Installation Manual page 23

5. When the Hard Drive Setup Complete screen displays,
remove the disk from the floppy drive and press
reboot the system.
To install an operating system on a new master hard drive, see
steps 6 through 8.
6. If EZ-BIOS installed, the following message displays during
the system boot. If this message does not display, EZ-BIOS
did not install; see your operating system manual for
installation instructions.
To install DOS from floppy, insert DOS
Setup Disk 1 into drive A. Type A to begin
DOS install.
Type C to skip DOS install and boot to
drive C.
7. Insert the operating system installation disk 1 and type A to
install the operating system. The following message displays.
EZ-BIOS:
Insert Boot Disk and
Press Any Key
Note: If you do not want to install your operating system at
this time, type C and follow the instructions in the section
Installing an Operating System from Floppy Disk with
EZ-BIOS Installed.
8. Press any key to begin operating system installation. Follow
the onscreen prompts to complete installation.
The operating system does not need to partition and format
the hard drive. EZ-Drive has already set up partitions and
formatted the hard drive.
Continuing startup
EZ-Drive Software Installation
to
ESC
19