Sharp MX-M950 Software Manual page 93

Select the special modes.
If the base screen is not displayed, touch the [Condition Settings] key.
(1) Make sure that the desired mode is selected.
If the desired mode is not selected, touch the tab of that mode.
(2) Touch the [Special Modes] key.
3
(3) Touch the [Erase] key.
☞
SPECIAL MODES
When you return to the base screen after specifying the destination, the base screen of the mode of the specified
destination appears.
(1)
Scan/Special Modes
Erase
Edge Center
Erase Erase
Side Erase
4
(page 87)
(2)
Cancel
Edge+Center
Edge
Erase
1/2
(0 1)
inch
Select the erase settings.
(3)
(1) Touch the desired erase mode.
OK
Select one of the 4 erase modes.
OK
Touch the [Side Erase] key to open the following screen.
Erase
Side Erase
Left
Touch the checkbox of the edge that you wish to erase
and make sure that a checkmark (
When performing two-sided scanning, set the erase edge
on the reverse side.
• If you touch the [Same Side as Side 1] key, the edge in
the same position as on the front side will be erased.
• If you touch the [Different Side from Side 1], the edge in
the position opposite to the erased edge on the front
side will be erased.
When you have completed the settings, touch the [OK]
key.
(2) Set the erasure width with the
0" to 1" (0 mm to 20 mm) can be entered.
(3) Touch the [OK] key.
93
Cancel
Erase position
Up
for Side 2
Right
Same Side as
Side 1
Different Side
from Side 1
Down
) appears.
OK
keys.