Sharp MX-M950 Software Manual page 55

Scan Internet Fax
Address Book
Original
Direct TX Exposure
Sub Address
Resolution
Address Review Special Modes
File
3
Quick File
The current settings for [Original], [Exposure], and [Resolution], are indicated at the right of each key. To change a
setting, touch the appropriate key.
☞
AUTOMATICALLY SCANNING BOTH SIDES OF AN ORIGINAL (2-Sided Original)
ORIGINAL SCAN SIZE AND SEND SIZE (Enlarge/Reduce)
EXPOSURE MODE (ORIGINAL IMAGE TYPE)
SPECIAL MODES
Fax/Original
Scan Size
Auto
4
2-Sided
2-Sided
Booklet Tablet
The original orientation is initially set to
necessary.
Press the [START] key (
Scanning begins.
• If the original is placed on the document glass, the [Read-End] key appears in the touch panel. If the original is only one
page, go to step 7. To scan more pages, go to the next step.
5
• If the original was inserted in the document feeder tray, a beep will sound when scanning is completed.
If "Fax Dest. Confirmation Mode" is enabled in the system settings (administrator), a destination confirmation message
will appear. See
If the original was placed on the document glass, replace it with the next original
6 and press the [START] key (
Repeat until all originals have been scanned.
(2) (1)
Fax Data Entry USB Mem. Scan
Auto 8½x11
Scan: Send:
Auto
Standard
Auto Reception
Fax Memory:100%
(page 87)
(1)
100% Send Size
8½x11 Auto
Image Orientation
).
"FAX DESTINATION CONFIRMATION
Display the original settings screen.
(1) Make sure that fax mode is selected.
If fax mode is not selected, touch the [Fax] tab.
Auto
(2) Touch the [Original] key.
(page 70),
(page 76), CHANGING THE RESOLUTION
Specify the orientation in which the
(2)
original is placed.
OK
When specifying the orientation of the image to be transmitted,
specify the orientation of the original placed in step 1.
(1) Touch the appropriate orientation key.
If the top edge of the original is up, touch the
the top edge of the original is to the left, touch the
key.
(2) Touch the [OK] key.
You will return to the screen of step 3.
. If the original was placed with the top edge up, this step is not
MODE" (page 61).
).
55
(page 69), SPECIFYING THE
CHANGING THE EXPOSURE AND
(page 78), 4.
key. If