Cisco Catalyst 3850 Manual page 68

Configure Access Interface Connectivity
Use the show storm-control command to confirm that the interfaces are configured for storm control.
show storm-control
Key: U - Unicast, B - Broadcast, M - Multicast
Interface
Type
---------
----
Gi1/0/1
Gi1/0/1
Gi1/0/2
Gi1/0/2
Gi1/0/3
Gi1/0/3
Gi1/0/4
Gi1/0/4
Use the show ip snooping command to confirm that the interfaces are configured for snooping.
show ip
Switch
Switch
snooping is configured on following VLANs:
10-13,100
snooping is operational on following VLANs:
10-13,100
snooping is configured on the following L3 Interfaces:
Insertion of option 82 is disabled
circuit-id default format: vlan-mod-port
remote-id: 2037.0653.c800 (MAC)
Option 82 on untrusted port is not allowed
Verification of hwaddr field is enabled
Verification of giaddr field is enabled
snooping trust/rate is configured on the following Interfaces:
Interface
-----------------------
GigabitEthernet1/0/1
Custom circuit-ids:
GigabitEthernet1/0/2
Custom circuit-ids:
GigabitEthernet1/0/3
Custom circuit-ids:
GigabitEthernet1/0/4
Custom circuit-ids:
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
58
Filter State Upper
------------- -----------
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
Link Down
snooping
snooping is enabled
gleaning is disabled
Trusted
-------
no
no
no
no
Lower
-----------
1k pps 1k pps
2k pps 2k pps
1k pps 1k pps
2k pps 2k pps
1k pps 1k pps
2k pps 2k pps
1k pps 1k pps
2k pps 2k pps
Allow option
------------
no
no
no
no
Access Interface Connectivity
Current Action
---------- ---------
0 pps Trap
0 pps Trap
0 pps Trap
0 pps Trap
0 pps Trap
0 pps Trap
0 pps Trap
0 pps Trap
Rate limit (pps)
----------------
100
100
100
100
B
M
B
M
B
M
B
M