Cisco Catalyst 3850 Manual page 38

Assign Initial Management Information
! Use "show spanning-tree vlan 100" to confirm VLAN 100 FWD on the uplink
! interface.
! Use "show interface trunk" to confirm GigabitEthernet 1/1/1 is
! operating in Trunk mode correctly.
show spanning-tree vlan
VLAN0100
Spanning tree enabled protocol rstp
Root ID
Bridge ID
Interface
------------------- ---- --- --------- --------
--------------------------------
Gi1/1/1
Gi1/1/2
show interfaces trunk
Port
Gi1/1/1
Gi1/1/2
Port
Gi1/1/1
Gi1/1/2
Port
Gi1/1/1
Gi1/1/2
Port
Gi1/1/1
Gi1/1/2
!
! Now the default gateway will respond to pings
!
ping 182.168.1.1
Enter the show running-configuration command to display the initial management information for the
Note
switch.
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
26
100
Priority 32868
Address 0022.bdd9.4c00
Cost 4
Port 49 (GigabitEthernet1/1/1)
Hello Time 2 sec
Priority 32868
Address 20bb.c05f.b300
Hello Time 2 sec
Aging Time 300 sec
Role Sts Cost
Root FWD 4
Altn BLK 4
Mode Encapsulation
on 802.1q
on 802.1q
Vlans allowed on trunk
1-4094
1-4094
Vlans allowed and active in management domain
1,100,999
1,100,999
Vlans in spanning tree forwarding state and not pruned
1,100,999
none
Max Age 20 sec Forward Delay 15 sec
(priority 32768 sys-id-ext 100)
Max Age 20 sec Forward Delay 15 sec
Prio.Nbr Type
128.49 P2p
128.50 P2p
Status
trunking
trunking
Initial Switch Configuration
Native vlan
999
999