Kst Select: ► Kst Config:) Receiver - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
CDM-570A/570AL ODU (Transceiver, BUC, LNB) Operation
(KST CONFIG: ► KST TX:) HPA ► Fault-Logic
HPA Fault Logic: Summary
No-Summary
To control whether or not HPA fault will activate the SUMMARY FAULT RELAY, use the
◄ ► arrow keys to select Summary or No-Summary. Press ENTER when done.
10.2.1.2.2.1.1.2
KST RX: Frequency
LNA
KST RX: Frequency
LNB
Use the ◄ ► arrow keys to select Frequency, Atten, or LNA/LNB, and then press ENTER.
(KST CONFIG: ► KST RX:) Frequency
ODU Rx Frequency:
10950.0 MHz (◄ ►,▲ ▼,ENT)
To edit the receive frequency, first use the ◄ ► arrow keys to select a digit, and then use
the ▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) Atten (Attenuation)
ODU Rx Attenuation:
15 dB
To edit the receive attenuation, first use the ◄ ► arrow keys to select a digit, and then use
the ▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) LNA
LNA: State
Calibrate
Use the ◄ ► arrow keys to select State, Fault-Logic, or Calibrate, and then press ENTER.
(KST CONFIG: ► KST RX:) LNA ► State
ODU LNA State:
On
To control whether or not the ODU provides LNA POWER via the Receive RF Cable, use
the ◄ ► arrow keys to select ON or OFF. Press ENTER when done.
(◄ ►,ENT)
(KST SELECT: ► KST CONFIG:) Receiver
Atten
(◄ ►,ENT)
Atten
(◄ ►,ENT)
(◄ ►,▲ ▼,ENT)
Fault-Logic
(◄ ►,ENT)
Off (◄ ►,ENT)
(Displayed when ODU is a KST-2000A unit)
(Displayed when ODU is a KST-2000B unit)
(Displayed when ODU is a KST-2000A unit)
10–20
MN-CDM570A
Revision 3