Clear Memory Mode - Subaru FORESTER 2004 Service Manual

10.Clear Memory Mode

A: OPERATION
1) Turn the ignition switch to ON.
2) Connect the ground terminal (ground, terminal
"A") to diagnosis connector terminal No. 1 in the in-
strument panel lower cover area.
(1)
(1) Diagnosis connector
(2) Ground terminal "B"
(3) Ground terminal "A"
3) While the airbag warning light flashes, connect
another ground terminal (ground, terminal "B") to
diagnosis connector terminal No. 2.
4) Once the memory is erased, the airbag warning
light returns to the normal flash rate (0.6 sec on).
The failure to recover the normal flash rate indi-
cates that trouble parts still remain. Having re-
paired such parts, erase the memory again and
confirm that the normal flash rate has returned.
5) When the memory has been cleared, disconnect
the ground terminal from the diagnosis connector.
6) Wind tape around the ground terminal and return
it to its original position.
Clear Memory Mode
(2)
(3)
1 2
B82
3 4 5 6
AB-00138
AB-33
AIRBAG SYSTEM (DIAGNOSTIC)