Clear Memory Mode - Subaru forester 2004 Service Manual

Clear Memory Mode

IMMOBILIZER (DIAGNOSTIC)
7. Clear Memory Mode
A: OPERATION
1) On the «Main Menu» display screen, select the
{Each System Check}, and then press the [YES] key.
2) On the «System Selection Menu» display screen,
select the {Engine Control System}, and then press the
[YES] key.
3) Press the [YES] key after displayed information
of engine type.
4) On the «Engine Diagnosis» display screen, se-
lect the {Clear Memory}, and then press the [YES]
key.
5) When the `Done' is shown on the display screen,
turn the Subaru Select Monitor and ignition switch
to OFF.
NOTE:
• After the memory has been cleared, the ISC must be
initialized.To do this, turn the ignition switch to ON po-
sition. Wait 3 seconds before starting the engine.
• For detailed operation procedure, refer to the SUB-
ARUSELECT MONITOR OPERATION MANUAL.
IM-9