Making A Push To Talk Call By Entering A Number; Missed Call Notification For Push To Talk Calls - Sanyo SCP-4920 User Manual

Making a Push to Talk Call by Entering a Number

To place a Push to Talk call by entering a number:
1.
From standby mode, enter the Push to Talk number you want to
dial.
2.
Press
take the floor and speak.
The contact's name appears on the display if there is a
matched number in your Push to Talk List.
3.
Continue with the Push to Talk call, pressing and holding
speak and releasing it to allow others to reply.
4.
When the call is finished, press
– or –
1. Press PTT (right softkey) or press
List.
2. Press Go to (left softkey), highlight Enter PTT# and press
3.
Enter the Push to Talk number you want to dial.
4.
Follow steps 2-4 above.
Note:
Push to Talk numbers must contain ten digits (area code + phone number).
Your Push to Talk number is the same as your phone number.

Missed Call Notification for Push to Talk Calls

When an incoming Push to Talk call is not answered, the Missed Call
Notification is displayed on your screen.
To call the last Missed Push to Talk call:
Simply press and hold
displayed. (Continue with the Push to Talk call as described
previously.)
To display the Missed Push to Talk Call Log:
Press View (right softkey). To call the entry, highlight the entry
you want to call, and press and hold
to Talk call as described previously.)
Note:
When you display Missed Calls entries, you will see the
name. The icon will remain until you make or receive a Push to Talk call to or
from the entry. The
to place the Push to Talk call. Continue holding
icon appears next to the new missed call entry.
.
to access the Push to Talk
while the Missed Call Notification is
. (Continue with the Push
to
to
.
icon next to the
104