Unpacking/Assembly; Before Use / Fitting; Markings On The Battery Package - 3M Adflo User Manual

1 ï
- None of the respiratory system filters can be connected directly to the head top.
- To determine the protection / class of the Adflo Respiratory System the user shall ensure
that the marking on the filter is not confused with markings on the filters relating to stan-
dards other than EN 12941:1998.
Caution: The face seal in this product contains components made from natural rubber latex
which may cause allergic reaction.

4. UNPACKING/ASSEMBLY

Check that correct number of components has been supplied, as in figure 1.
Check that the apparatus is complete, undamaged and correctly assembled, any damaged or
defective parts must be replaced before use.
- Install the automatic welding filter in the welding head top, using the instructions included
with the welding shield. NOTE! Always use inside and outside protection plates.
- Install the headband in the welding head top, and connect the face seal to the headband,
figure 4.
- Install the Adflo unit on the belt, figure 5.
- Connect the breathing tube between the welding head top and the Adflo unit, figure 6. Check
that the breathing tube is securely fastened.
Carefully observe the instructions that explain how the equipment is to be used, before taking
it into service.
All components must be installed/used in accordance with this manual if the equipment is to
offer the specified protection. If any component is missing, or if anything is not clear, contact
the supplier.

Markings on the battery package.

= Read the instructions before use.
= Contains Nickel Metal Hydride.
= Plastics materials can be re-cycled.
= Must not be disposed of in general waste, but should be disposed of
according to local regulations regarding waste material

5. BEFORE USE / FITTING

5.1 Battery charging, figure 7.
The battery charger is designed for fast charging of batteries with 6 to 12 cells with capacity
2,5 to 4,5 Ah. The battery has a charging contact, so that it can be charged when installed in
the Adflo unit, or separately.
All new units must be charged before they are used for the first time.
The charger must not be used in any circumstances for any other purpose than that for which
it was manufactured. It is intended for indoor use (must be protected from damp) and must not
be used to charge non-rechargeable batteries.
The charger controls the charging automatically.
The battery will be fully charged in about 4 hours (also the heavy duty battery) this depends
on residual capacity.
6