Table of Contents
Advertisement
Setting a Wait Time for Connecting to a Network
When a network is designed to enjoy redundant connectivity with multiple switching hubs or bridges, it must have a
mechanism to prevent packets from looping. One effective solution is to define the role of each switch port. However,
communication may still be disrupted for several tens of seconds immediately after you change the way that network
devices are connected, or if you add a new device. If this type of problem occurs, set a wait time for connecting to the
network.
1
Press
(
2
Use
/
to select <Network>, and press
●
When a message appears, press
3
Select <Wait Time at Startup>, and press
4
Enter the wait time in seconds, and press
●
Use the numeric keys to enter the time.
5
Perform a hard reset.
➠
The settings are enabled after the hard reset is performed.
LINKS
Configuring Ethernet Settings(P. 210)
).
.
Performing a Hard Reset(P. 448)
Network
.
.
.
212
167A-03F
Advertisement
Table of Contents
