Removal - NEC Express5800/T120d User Manual

Chapter 2 Preparations
7. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
8. Start the configuration utility installed on the mounted board to set up the board.
Availability or startup and operation procedure of the utility depends on board. For details, refer to the
manual that comes with the board. If a PCI board including RAID Controller, SCSI controller, and
LAN adapter which connects to any bootable device is added, the boot priority might be changed
to the default setting. In that case, configure the boot priority in Boot menu of BIOS Setup Utility. For
details, refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
(1) When using the optional controller (N8103-149/150/151/160)
For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151/160).

1.12.4 Removal

To remove a PCI board, reverse the installation procedure.
Run SETUP and change boot order in Boot menu. Refer to Chapter 3 (2. System BIOS Setup) for how to
specify it.
If using the server while the board is removed, attach the blank cover that comes with the PCI slot.
• You must avoid static electricity to work with the procedure below. For
Important
details, refer to Chapter 2 (1.2 Anti-static Measures).
• Do not change the mode to hibernate during building a RAID System.
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Express5800/T120d User's Guide
1. Installing Internal Optional Devices
85