Ers8600C Configuration - Avaya 8600 Technical Configuration Manual

enable
config ethernet 2/1 ip rip enable
4 Enable RIP Globally
config ip rip enable
4.7

ERS8600C Configuration:

1 Configuration for Access VLAN 2
config vlan 2 create byport 1
config vlan 2 ports add 1/48
config vlan 2 ip create 10.1.40.2/24
config vlan 2 ip rip enable
config vlan 2 ip supply disable
config vlan 2 ip listen disable
2 Configuration of Brouter port #1
config ethernet 2/8 ip create 10.1.1.6/30
2090
config ethernet 2/8 ip rip default-listen
enable
config ethernet 2/8 ip rip enable
3 Configuration of Brouter port #2
config ethernet 2/1 ip create 10.1.1.14/30
2091
config ethernet 2/1 ip rip default-listen
enable
config ethernet 2/1 ip rip default-supply
enable
config ethernet 2/1 ip rip enable
November 2010
ERS 8600 / ERS 8800 RIP Technical Configuration Guide
This command creates VLAN = 2 using Spanning Tree
Group = 1. If using another STG group, create the new
STG group first, then add port 1/48 to the new STG
group.
This command adds the access port 1/48 to VLAN 2.
This command adds the IP address of 10.1.20.2/24 to
VLAN 2
This command enables RIP for VLAN 2 and disables RIP
supply and listen.
This command adds the IP address of 10.1.1.6/30 to port
2/8 using brouter VLAN = 2090.
These commands enable RIP and default route listen for
this port.
This command adds the IP address of 10.1.1.14/30 to
port 2/1 using brouter VLAN = 2091.
These commands enable RIP and default route supply
and listen for this interface.
avaya.com
17