Controller Keypad; Generator Set Master Switch - Kohler 17RES Operation Manual

buttons are used to step through the other displays as
described in Section 2.3.2.
When the master switch is in AUTO, the display turns off
48 hours after generator set shutdown.
Section 2.4.
2.3.2

Controller Keypad

The three buttons on the controller keypad are Select,
Up, and Down.
When the generator set is running, the up and down
arrow buttons can be used to step through system data
displays as shown in Figure 2-2. After 10 seconds, the
display returns to engine runtime hours.
The buttons on the controller keypad are also used for
system configuration and adjustment.
configuration is factory-set and should not require
changes under normal operating conditions. Contact an
authorized distributor/dealer or service technician if
adjustments are required.
Control or Indicator Item
Runtime hours
LED display
Metering display
Crank indication
Software version
number
Fault codes
Keypad Select and arrow
buttons
Generator set master Three-position
switch switch
Figure 2-3 ADC-RES Controls and Indicators
14 Section 2 Operation
2.3.3
The generator set master switch is located on the
junction box below the ADC-RES user interface. The
See master switch positions are RUN, OFF/RESET, and
AUTO. See Section 2.5 for operation instructions.
The system
1. Generator set master switch in AUTO
2. Step through using up or down arrow buttons
3. After 10 seconds, display returns to runtime hours
Figure 2-2 Data Displays
Description
Displays total generator set runtime hours while the generator set is running and when no
other codes are displayed.
Displays AC voltage (output), frequency, and battery voltage. Press the up or down arrow
when runtime hours are displayed to step through these displays.
Displays CC_1, CC_2, or CC_3 to indicate the first, second, or third attempt to start the
engine. The last digit flashes during the crank cycle rest periods.
The software version number (v#.##) is displayed when entering configuration mode. See
the Installation Manual.
Flashes a 2- or 3-letter fault code to indicate various fault conditions. See Section 2.6.
Use the arrow buttons to step through the data displays. See Figure 2-2.
The keypad is also used for controller setup and adjustment. The setup and adjustment
functions are password-protected. Have setup and adjustments performed only by an
authorized distributor/dealer.
Switch functions as the generator set operation and controller reset switch.

Generator Set Master Switch

Engine Runtime
XXX.X hours
Output Voltage
VAC
Output Frequency
Hz
Battery Voltage
VDC
tp6515
TP-6515 10/07