Additional) Configuration Required To Use Community - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 16 Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant
Command
Step 5
Switch(config)# ip http timeout-policy idle
idle_time life life_time requests requests
Step 6
Switch(config-if)# end
Step 7
Switch# show running-config
If you have enabled clustering, disable clustering before configuring a community (see
Note

(Additional) Configuration Required to Use Community

If you plan to use community, define an IP address on each switch.
To configure a switch to use community, perform this task:
Command
Step 1
Switch# configuration terminal
Step 2
Switch(config)# interface {vlan vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
Step 3
Switch(config-if)# ip address ip_address
address_mask
Step 4
Switch(config-if)# end
Step 5
Switch# show running-config
(Additional) Configuration Required to Use Clustering
If you plan to use clustering, enter the cluster run global configuration command on each device and
enter the ip address interface configuration command on the cluster commander.
To configure a switch to use clustering, perform this task:
|
Port-channel number}
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Configuring Your Switch for Network Assistant
Purpose
Configures the HTTPS port.
The idle keyword specifies the maximum amount of time a
connection can stay idle. A idle value of 180 seconds is
recommended.
The life keyword specifies the maximum amount of time a
connection can stay open since it was established. A life
value of 180 seconds is recommended.
The requests keyword specifies the maximum amount of
requests on a connection. The recommended maximum
number of requests allowed is 25.
Returns to privileged EXEC mode.
Verifies the configuration.
Purpose
Enters global configuration mode.
Selects an interface.
(Optional) Assigns an IP address to the Catalyst 4500 series.
Note This step is mandatory if the switch is part of
community or is a cluster command switch. This step
is optional if the switch is a cluster member
candidate.
Returns to privileged EXEC mode.
Verifies the configuration.
Table 16-2).
16-5