Table; Configuring Mvr - Cisco Catalyst 4500 Series Software Configuration Manual

Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 28
Configuring IGMP Snooping and Filtering, and MVR
Because MVR multicast traffic is sent only on mVLANs, duplicating television-channel multicast traffic
for subscribers on different VLANs is unnecessary. The IGMP leave and join messages are in the VLAN
to which the subscriber port is assigned. The access layer switch (Switch A) modifies the forwarding
behavior to allow traffic forwarding from the multicast VLAN to the subscriber port in a different
VLAN. This is done by selectively allowing traffic to cross between the two VLANs.
IGMP reports are sent to the same IP multicast group address as the multicast data. The Switch A CPU
must capture all IGMP join and leave messages from the receiver ports and forward them to the multicast
VLAN of the source (uplink) port, based on the MVR mode.

Configuring MVR

These sections include basic MVR configuration information:
Default MVR Configuration
Note
Enabling the MVR command will set all the MVR default parameters.

Table 28-2

Table 28-2
Feature
MVR
Multicast addresses
Query response time
Multicast VLAN
Mode
Interface (per port) default
Immediate Leave
MVR Configuration Guidelines and Limitations
Follow these guidelines when configuring MVR:
Default MVR Configuration, page 28-23
MVR Configuration Guidelines and Limitations, page 28-23
Configuring MVR Global Parameters, page 28-24
Configuring MVR on Access Ports, page 28-26
Configuring MVR on a Trunk Port, page 28-27
Displaying MVR Information, page 28-29
shows the default MVR configuration.
Default MVR Configuration
Ports can be configured as either a source port or a receiver port.
Ports connected to subscribers are configured as receiver ports.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Default Setting
Disabled globally
None configured
5 (tenths of a second)
VLAN 1
Compatible
Neither a receiver nor a source port
Disabled on all ports
Configuring MVR
28-23

Advertisement

Table of Contents
loading

Table of Contents