Cisco Catalyst 4500 Series Software Configuration Manual page 379

Chapter 7 Configuring the Cisco IOS In-Service Software Upgrade Process
Switch# show redundancy states
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured)
Redundancy State
Maintenance Mode = Disabled
Manual Swact = enabled
Communications = Up
client count = 39
client_notification_TMR = 240000 milliseconds
keep_alive threshold = 18
The following example shows how the forced option places the system in RPR mode:
Switch> enable
Switch# issu loadversion 1 bootflash:new_image 2 slavebootflash:new_image forced
Switch# show issu state detail
The following example shows the redundancy mode as RPR:
Switch# show redundancy states
Redundancy Mode (Operational) = RPR
Redundancy Mode (Configured)
Redundancy State
Maintenance Mode = Disabled
Manual Swact = enabled
Communications = Up
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 1
keep_alive TMR = 9000 milliseconds
keep_alive count = 1
RF debug mask = 0x0
Slot = 1
RP State = Active
ISSU State = Load Version
Boot Variable = bootflash:old_image,12
Operating Mode = RPR
Primary Version = bootflash:old_image
Secondary Version = bootflash:new_image
Current Version = bootflash:old_image
Slot = 2
RP State = Standby
ISSU State = Load Version
Boot Variable = bootflash:new_image,12;bootflash:old_image,12
Operating Mode = RPR
Primary Version = bootflash:old_image
Secondary Version = bootflash:new_image
Current Version = bootflash:new_image
my state = 13 -ACTIVE
peer state = 4 -STANDBY COLD
Mode = Duplex
Unit = Primary
Unit ID = 1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.0E and IOS 15.2(5)E
= Stateful Switchover
= Stateful Switchover
= Stateful Switchover
= RPR
Performing the ISSU Process
7-23