Cisco Catalyst 4500 Series Software Configuration Manual page 1093

Chapter 43 Configuring VRF-lite
Command
Switch(config-if)# ospfv3 process-id
Step 4
area area-ID {ipv4 | ipv6} [instance
instance-id]
Or
Switch(config-if)# ipv6 ospf
process-id area area-ID [instance
instance-id]
Switch(config-if)# end
Step 5
This example show how to enable OSPFv3 on an interface:
Switch(config)# interface GigabitEthernet2/1
Switch(config-if)# no switchport
Switch(config-if)# ipv6 address 4000::2/64
Switch(config-if)# ipv6 enable
Switch(config-if)# ipv6 ospf 1 area 0
Switch(config-if)# end
EIGRP
To configure an EIGRPv6 routing process, perform the following steps:
Command
Switch> enable
Step 1
Switch# configure terminal
Step 2
Switch(config)# router eigrp
Step 3
virtual-instance-name
Switch(config-router)#
Step 4
address-family ipv6 vrf vrf-name
autonomous-system
autonomous-system-number
Switch(config-router-af)# topology
Step 5
{base | topology-name tid number
Switch(config-router-af-topology)#
Step 6
exit-aftopology
Switch(config-router)# eigrp
Step 7
router-id ip-address
Switch(config-router)# end
Step 8
This example shows how to configure an EIGRP routing process:
Switch(config)# router eigrp test
Switch(config-router)# address-family ipv6 unicast vrf b1 autonomous-system 10
Switch(config-router-af)# topology base
Switch(config-router-af-topology)# exit-af-topology
Switch(config-router)# eigrp router-id 2.3.4.5
Switch(config-router)# exit-address-family
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Enables OSPFv3 on an interface with the IPv4 or IPv6 AF.
or
Enables OSPFv3 on an interface.
Returns to privileged EXEC mode.
Purpose
Enters privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Configures the EIGRP routing process and enters router
configuration mode.
Enables EIGRP IPv6 VRF-Lite and enters address family
configuration mode.
Configures an EIGRP process to route IP traffic under the
specified topology instance and enters address family
topology configuration mode.
Exits address family topology configuration mode.
Enables the use of a fixed router-id.
Exits router configuration mode.
Configuring VRF-lite for IPv6
43-25