Cisco Catalyst 4500 Series Software Configuration Manual page 463

Table 9-4 Sup 8-E Uplink Configuration Modes
Supervisor
Configuration Uplink Ports
Single Supervisor 4x10GE
(Sup7E Mode)
Single Supervisor 4x10GE
Single Supervisor 8x10GE
Single Supervisor 8x10GE
Dual Supervisor Active Supervisor:
(Sup 7-E mode) 2x10GE
Standby Supervisor:
2x10GE
Dual Supervisor Active Supervisor:
2x10GE
Standby Supervisor:
2x10GE
Dual Supervisor Active Supervisor:
4x10GE
Standby Supervisor:
4x10GE
Chapter 9 Configuring Interfaces
Wireless
Termination/Daughter
Card
20GE
20GE
20GE
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
Configuring Supervisor Engine 7-E Uplink Mode on Supervisor Engine 8-E
Linecard/Chassis
Restrictions
10-slot Chassis: No
restriction
3,6 and 7 Slot Chassis:
Configuration not
supported
10-slot Chassis:
Restriction on the 10th
slot.*
3,6 and 7 Slot Chassis:
No restriction
10-slot Chassis:
Restriction on the 10th
slot.*
3,6 and 7 Slot Chassis:
No restriction
10-slot Chassis:
Restriction on the 10th
slot.*
Wireless/Daughter Card
enabled.
3,6 and 7 Slot Chassis:
No restriction
10-slot Chassis: No
restriction
3,6 and 7 Slot Chassis:
Configuration not
supported
10-slot Chassis:
Restriction on the 10th
slot.*
3,6 and 7 Slot Chassis:
Configuration not
supported
10-slot Chassis:
Restriction on the 10th
slot.*
3,6 and 7 Slot Chassis:
No restriction
User Configuration
Requires CLI
configuration followed
by a supervisor engine
reload.
Default configuration in
Install Boot mode.
Default configuration in
Bundle Boot mode.
Default configuration in
Install Boot mode.
Requires CLI
configuration to force
disable the daughter card
followed by a supervisor
engine reload.
Default configuration in
Install Boot mode.
Requires CLI
configuration followed
by a supervisor engine
reload.
Default configuration in
Install Boot mode.
Default configuration in
Bundle Boot mode.
Requires CLI
configuration followed
by a supervisor engine
reload.