Configuring Learning Methods - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 28 Configuring IGMP Snooping and Filtering, and MVR
This example shows how to enable IGMP snooping on VLAN 2 and verify the configuration:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 2
Switch(config)# end
Switch# show ip igmp snooping vlan 2
Global IGMP Snooping configuration:
-----------------------------------
IGMP snooping
IGMPv3 snooping
Report suppression
TCN solicit query
TCN flood query count
Vlan 2:
--------
IGMP snooping
IGMPv2 immediate leave
Explicit host tracking
Multicast router learning mode : pim-dvmrp
CGMP interoperability mode

Configuring Learning Methods

The following sections describe IGMP snooping learning methods:
•
•
Configuring PIM/DVMRP Learning
To configure IGMP snooping to learn from PIM/DVMRP packets, perform this task:
Command
Switch(config)# ip igmp snooping vlan
vlan_ID mrouter learn [cgmp | pim-dvmrp]
This example shows how to configure IP IGMP snooping to learn from PIM/DVMRP packets:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 1 mrouter learn pim-dvmrp
Switch(config)# end
Switch#
Configuring CGMP Learning
To configure IGMP snooping to learn from CGMP self-join packets, perform this task:
Command
Switch(config)# ip igmp snooping vlan
vlan_ID mrouter learn [cgmp | pim-dvmrp]
: Enabled
: Enabled
: Enabled
: Disabled
: 2
Configuring PIM/DVMRP Learning, page 28-7
Configuring CGMP Learning, page 28-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
: Enabled
: Disabled
: Enabled
: IGMP_ONLY
Purpose
Specifies the learning method for the VLAN.
Purpose
Specifies the learning method for the VLAN.
Configuring IGMP Snooping
28-7