Omron E5CN-HT Communications Manual page 100

SECTION 5 Communications Data for Modbus
Address
Parameter name
Four-byte Two-byte
mode mode
0700 2700 Cooling Coefficient (See note 1.) H'00000001 to H'0000270F (0.01 to 99.99)
0708 2704 Dead Band
070A 2705 Manual Reset Value
070C 2706 Hysteresis (Heating)
070E 2707 Hysteresis (Cooling)
0710 2708 Control Period (Heating)
0712 2709 Control Period (Cooling)
0714 270A Position Proportional Dead
Band
0716 270B Open/Close Hysteresis
071E 270F MV at Reset
Note 1: The parameter for the currently selected PID set will be accessed. For setup area 1, however, the currently selected PID
set is fixed at PID1.
5-4
Setting (monitor) value
Temperature: H'FFFFB1E1 to H'00007E90 (−1999.9 to 3240.0)
Analog: H'FFFFF831 to H'0000270F (−19.99 to 99.99)
H'00000000 to H'000003E8 (0.0 to 100.0)
Temperature: H'00000001 to H'00007E90 (0.1 to 3240.0)
Analog: H'00000001 to H'0000270F (0.01 to 99.99)
Temperature: H'00000001 to H'00007E90 (0.1 to 3240.0)
Analog: H'00000001 to H'0000270F (0.01 to 99.99)
H'00000000 (0): 0.5
H'00000001 to H'00000063 (1 to 99)
H'00000000 (0): 0.5
H'00000001 to H'00000063 (1 to 99)
H'00000001 to H'00000064 (0.1 to 10.0)
H'00000001 to H'000000C8 (0.1 to 20.0)
Standard: H'FFFFFFCE to H'0000041A (−5.0 to 105.0)
Heating/cooling: H'FFFFFBE6 to H'0000041A (−105.0 to 105.0)
Position proportional (Floating or direct setting of position proportional MV
OFF): H'FFFFFFFF to H'00000001 (−1 to 1)
Position proportional (Closed and direct setting of position proportional MV
ON): H'FFFFFFCE to H'0000041A (−5.0 to 105.0)
Level
Adjustment
Initial
setting
Adjustment
Adjustment