Linking Trays - Dell S3840cdn User Manual

Envelope #10, Monarch, DL
Load the envelopes with the flaps closed and the print side facing up. Make sure that the
flaps are on the left side when you face towards the printer.
C5
Load the envelopes in the short edge feed orientation with the flaps open or closed and
the print side up. Ensure that the flaps come at the bottom with the flaps open or at the
top with the flaps closed when you face towards the printer.
NOTE:
• When you print with the flaps open, position of the envelopes may be distorted on the output tray.
In this case, close the flaps when you load the envelopes.

Linking Trays

The printer links the Tray 1 and the optional 550-sheet feeder when you load the same
size and type of print media in them. The first tray is utilized until the print media runs out
after which the next tray is used.
NOTE:
• The print media should be the same size and type in each tray.
• The bypass tray cannot be linked to any of the tray sources.
After loading the selected trays with the same size and type of print media, specify the
paper type for the trays under Trays in the Dell Printer Configuration Web Tool.
To disable tray linking, change the paper type for one of the trays to a unique value.
NOTE:
• If different types of print media of the same size are loaded in the trays, the printer links them if the
paper type is not specified in the print driver properties/preferences.
138
| Loading Print Media