HP 6125XLG Ip Multicast Configuration Manual page 329

Device
Switch E
Switch F
Switch F
Switch F
Switch G
Switch G
Switch H
Switch H
Switch I
Switch I
Source 1
Source 2
Source 3
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to
shown.)
2. Configure OSPFv3 on all switches on the IPv6 PIM-SM network to meet the following requirements:
(Details not shown.)
The switches are interoperable at the network layer.
The switches can dynamically update their routing information.
3. Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM:
# On Switch A, enable IPv6 multicast routing.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
# Enable MLD on VLAN-interface 100 (the interface that connects to the receiver host).
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] quit
# Enable IPv6 PIM-SM on VLAN-interface 101.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 pim sm
[SwitchA-Vlan-interface101] quit
# Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM on Switch E and Switch I in the same way
Switch A is configured. (Details not shown.)
# On Switch B, enable IPv6 multicast routing, and enable IPv6 PIM-SM on each interface.
<SwitchB> system-view
[SwitchB] ipv6 multicast routing
[SwitchB-mrib6] quit
[SwitchB] interface vlan-interface 200
Interface
VLAN-interface 108
VLAN-interface 109
VLAN-interface 107
VLAN-interface 102
VLAN-interface 500
VLAN-interface 109
VLAN-interface 110
VLAN-interface 106
VLAN-interface 600
VLAN-interface 110
—
—
—
319
IPv6 address
6001::2/64
8001::1/64
6002::2/64
2003::2/64
9001::1/64
8001::2/64
4001::1/64
3004::2/64
5001::1/64
4001::2/64
2001::100/64
3001::100/64
9001::100/64
Figure 100. (Details not