HP 6125XLG Ip Multicast Configuration Manual page 173

Device
Switch B
Switch B
Switch B
Switch C
Switch C
Switch C
Switch C
Switch C
Switch D
Switch D
Switch D
Switch D
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Configure OSPF on the switches in the PIM-SM domains to meet the following requirements:
(Details not shown.)
The switches are interoperable at the network layer.
The switches can dynamically update routing information.
3. Enable IP multicast routing, IGMP, and PIM-SM, and configure a PIM domain border:
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable IGMP on VLAN-interface 100 (the interface that connects to the receiver host).
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] quit
# Enable PIM-SM on the other interfaces.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
[SwitchA] interface loopback 0
[SwitchA-LoopBack0] pim sm
[SwitchA-LoopBack0] quit
# Enable IP multicast routing, IGMP, and PIM-SM on Switch B, Switch C, and Switch D in the same
way Switch A is configured. (Details not shown.)
Interface
VLAN-interface 200
VLAN-interface 102
VLAN-interface 103
VLAN-interface 300
VLAN-interface 104
VLAN-interface 101
VLAN-interface 103
Loopback 0
VLAN-interface 400
VLAN-interface 500
VLAN-interface 104
Loopback 0
163
IP address
10.110.3.1/24
10.110.2.2/24
192.168.2.1/24
10.110.4.1/24
10.110.5.1/24
192.168.1.2/24
192.168.2.2/24
2.2.2.2/32
10.110.6.1/24
10.110.7.1/24
10.110.5.2/24
3.3.3.3/32
Figure 55. (Details not