Configuring Static Ports - HP 6125XLG Ip Multicast Configuration Manual

Setting the aging timers for dynamic ports globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Set the aging timer for
dynamic router ports globally.
4. Set the aging timer for
dynamic member ports
globally.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for
the dynamic router ports
in the VLAN.
4. Set the aging timer for
the dynamic member
ports in the VLAN.

Configuring static ports

You can configure a port as a static port for the following purposes:
To make all the hosts attached to the port receive IPv6 multicast data for an IPv6 multicast group,
•
configure the port as a static member port for the group.
To make the Layer 2 device attached to the port forward all received IPv6 multicast traffic on the port,
•
configure the port as a static router port.
You can also configure a port as a static router port, through which the switch can forward all IPv6
multicast traffic it receives.
When you configure static ports, follow these guidelines:
A static member port does not respond to queries from the MLD querier. When you configure a port
•
as a static member port or cancel this configuration on the port, the port does not send unsolicited
MLD reports or MLD done messages.
Static member ports and static router ports never age out. To remove such a port, use the
•
corresponding undo command.
Configuration procedure
To configure static ports:
Step
1. Enter system view.
Command
system-view
mld-snooping
router-aging-time interval
host-aging-time interval
Command
system-view
vlan vlan-id
mld-snooping router-aging-time
interval
mld-snooping host-aging-time
interval
Command
system-view
221
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A