HP 6125XLG Ip Multicast Configuration Manual page 326

[SwitchE-acl6-basic-2005] rule permit source ff0e::101 64
[SwitchE-acl6-basic-2005] quit
# Configure VLAN-interface 102 as a C-BSR and a C-RP, and configure VLAN-interface 101 of
Switch D as the static RP.
[SwitchE] ipv6 pim
[SwitchE-pim6] c-bsr 1003::2
[SwitchE-pim6] c-rp 1003::2 group-policy 2005
[SwitchE-pim6] static-rp 1002::2
[SwitchE-pim6] quit
# On Switch A, configure VLAN-interface 101 of Switch D as the static RP
[SwitchA] ipv6 pim
[SwitchA-pim6] static-rp 1002::2
[SwitchA-pim6] quit
# Configure the static RP on Switch B, Switch C, and Switch D in the same way Switch A is
configured. (Details not shown.)
Verifying the configuration
# Display IPv6 PIM information on Switch A.
[SwitchA] display ipv6 pim interface
Interface
Vlan100
Vlan101
Vlan102
# Display BSR information on Switch A.
[SwitchA] display ipv6 pim bsr-info
Scope: non-scoped
State: Accept Preferred
Bootstrap timer: 00:01:44
Elected BSR address: 1003::2
Priority: 64
Hash mask length: 126
Uptime: 00:11:18
# Display BSR information on Switch E.
[SwitchE] display ipv6 pim bsr-info
Scope: non-scoped
State: Elected
Bootstrap timer: 00:01:44
Elected BSR address: 1003::2
Priority: 64
Hash mask length: 126
Uptime: 00:11:18
Candidate BSR address: 1003::2
Priority: 64
Hash mask length: 126
# Display RP information on Switch A.
[SwitchA] display ipv6 pim rp-info
NbrCnt HelloInt DR-Pri
0 30 1
1 30 1
1 30 1
316
DR-Address
FE80::A01:201:1
(local)
FE80::A01:201:2
FE80::A01:201:3