Configuring Ipv6 Pim-Sm; Ipv6 Pim-Sm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Sm - HP 6125XLG Ip Multicast Configuration Manual

For more information about the configuration of other timers in IPv6 PIM-DM, see
IPv6 PIM timers."
To configure the IPv6 PIM-DM graft retry timer:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the graft retry timer.

Configuring IPv6 PIM-SM

This section describes how to configure IPv6 PIM-SM.

IPv6 PIM-SM configuration task list

Task at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
NOTE:
Perform at least one of the tasks.
In a network with a static RP, skip the task of configuring a BSR.
Configuring a
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure IPv6 PIM-SM, configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.

Enabling IPv6 PIM-SM

Enable IPv6 multicast routing before configuring IPv6 PIM.
Enabling IPv6 PIM-SM:
Configuring an RP
BSR:
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling the BSM semantic fragmentation function
Configuring IPv6 multicast source registration
Configuring switchover to SPT
Configuring common IPv6 PIM features
Command
system-view
interface interface-type
interface-number
ipv6 pim timer graft-retry interval
292
"Configuring common
Remarks
N/A
N/A
By default, the graft retry timer is 3
seconds.