Replacement Interval; Installing And Removing Hardware; Replacing Rechargeable Battery - Siemens SIMATIC ITP1000 Operating Instructions Manual

Device maintenance and repair

5.2 Replacement interval

5.2 Replacement interval
To maintain high system availability, we recommend the preventative replacement of those
PC components that are subject to wear in accordance with the intervals for replacement
indicated in the table below:
Component
SSD
Backup battery
5.3

Installing and removing hardware

5.3.1

Replacing rechargeable battery

Observe the danger notices
Read the notes and information on the proper use and correct disposal of batteries in
section "Notes on battery operation (Page 32)".
Requirement
The device is completely isolated from the line voltage.
Torx 8 screwdriver
An original replacement part, refer to section "Accessories (Page 21)".
Procedure
1. Turn the device over so that it is lying on a flat surface.
2. Remove the two screws
54
WARNING
①
Replacement interval
3 years
5 years
on the underside of the device and store these safely.
Operating Instructions, 05/2017, A5E37340160-AB
SIMATIC ITP1000