Devise Functions And Operating The Device; Notes On Operation; Operating The Device - Siemens SIMATIC ITP1000 Operating Instructions Manual

Devise functions and operating the device

4.1

Notes on operation

4.1.1

Operating the device

You can operate the device in the following service positions.
Operating device on table
● Place the device on a flat, even, clean and stable base surface,
such as a desk.
● Protect the device adequately against inadvertent falling, i.e. do not place the device over
the edge of the surface.
● Make sure that the ventilation slots are not covered.
Mobile use of device
● For mobile use, hold the device on the right- and left-hand sides.
● Make sure that the ventilation slots are not covered.
Risk of damage to the device
Make sure to protect the device from inadvertent falling.
Operating device in docking station
● Place the device in the docking station (Page 19).
● Place the docking station on a stable, flat base, such as a desk.
● Connect the docking station to the power supply. To do so, only use the external power
supply unit supplied with the device or an original power supply unit.
● The LAN and USB interfaces on the docking station are only active when the docking
station is connected to the external power supply unit.
● Make sure that the devices latches properly into the docking station. This is necessary for
the battery to charge during operation of the device in the docking station. You can check
the current charging status of the battery using the "Battery" LED.
Remove device from docking station
● Tilt the device slightly forward to release it from the magnetic latching.
● Then remove the device by pulling it upwards.
SIMATIC ITP1000
Operating Instructions, 05/2017, A5E37340160-AB
CAUTION
4
43