Use Rfid Reader; Using Sd Cards And Multimedia Cards - Siemens SIMATIC ITP1000 Operating Instructions Manual

4.1.5

Use RFID reader

Information about the position of the RFID reader can be found in the section "Front
(Page 13)".
The RFID reader is freely configurable.
Technical support is available from SIEMENS Customized Automation
(hhttp://w3.siemens.com/mcms/human-machine-interface/en/customized-
products/Pages/Default.aspx).
Recording RFID tag
1. Press the key to activate the RFID reader Refer to the Configuration of the function keys
(Page 17).
The RFID reader is active for 30 seconds after activation.
2. Guide the RFID tag at the RFID reader.
3. The RFID tag is output at the current cursor position of an opened program.
4.1.6

Using SD cards and multimedia cards

You can use the following cards with the Card Reader:
● SD card (including SD UHS-II)
● MMC (Multi Media Card)
Information about the position of the card reader can be found in the section "Front
(Page 13)".
The contact areas of the card face downward and point toward the display. When inserting
the card, pay attention to the correct positioning of the card.
To remove the card press it lightly towards the device.
The card is operated by a push-push function.
NOTICE
Do not insert or remove cards while in use.
Inserting or removing a card while it is in use could damage it.
The card may not be removed as long the LED is lit, see section "Status displays
(Page 18)".
Observe the ESD guidelines (Page 71).
SIMATIC ITP1000
Operating Instructions, 05/2017, A5E37340160-AB
Devise functions and operating the device
4.1 Notes on operation
47