Sony HVR-Z5C Service Manual page 243

3-17. FP-228 Flexible Board
1. Removal procedure
1) Remove soldering at two locations 1 on the FP-031 board
and the FP-228 flexible board, and remove the FP-228 flex-
ible board (DEW SENSOR) 2 from the mechanism chassis.
2 FP-228 Flexible board
FP-031 Flexible board
HVR-Z5C/Z5E/Z5J/Z5N/Z5P/Z5U
(DEW SENSOR)
2. Attachment procedure
1) Attach the FP-228 flexible board (DEW SENSOR) 2 to the
mechanism chassis and attach the FP-031 board to the FP-228
board.
2) Solder the terminal block at two locations 1 on the FP-031
flexible board.
FP-031 Flexible board
Soldering
FP-228 Flexible board
1 Soldering at the
two locations
Soldering
Points to be noted
Use the rubber finger tip cover.
Lead-free solder
∅
Wire type : 0.6
Soldering iron : 941 made by Hakko Mfg.
Soldering iron tip : T1-1BC
Soldering iron tip temperature
Soldering iron tip contacting time: within 2 sec.
Be careful not to create the hollow soldering,
bridge formation, and the holder's claw must not be melt.
6-73
Mechanism chassis
: 300 ± 10 ° C