Honeywell HC900 User And Installation Manual page 259

16 Point Analog Output
Step
4
Connect field wiring.
RTP A for
Outputs 1 to 8, 9+ and 10+
RTP B for
Outputs 11 to 16, 9- and 10-)
16 Point Analog Input
Step
1
ATTENTION: RTP and cables are intended for permanent installation within their own enclosure.
ATTENTION: The RTP labeled "DI, DO, AO RTP ASSY" with jumpers J2-J9 is the correct one for 16
point AI.
Mount RTP cable assembly to HC900 Controller (Figure 96).

Remove appropriate key tabs from terminal board to allow mating with the module. See page 85.

Connect terminal block end of desired cable assembly to 16 point Analog Input module at controller.
Choose from:
900RTC-3210
900RTC-3225

Install 16 point Analog Input label into the module connector cover.

Connect both shield drain wires to the grounding bars at the base of the HC900 rack. All field-wiring
shields must be grounded as described in the shield grounding section (page 81).
Revision 6
21 April 2017
ETC.
1 2 3 4 5 6
21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
1 2 3 4 5 6
21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
External 24VDC supply
Remote Terminal Cable assembly, 1.0 meters long
Remote Terminal Cable assembly, 2.5 meters long
HC900 Process & Safety Controller User and Installation Manual
Action
LOADS ARE 0 to 750 ohm
9 10 11 12 13 14 15 16 17 18 19 20
7 8
9 10 11 12 13 14 15 16 17 18 19 20
7 8
EXT +24V Install 24V wires as shown:
EXT 24V RTN
Action
22 to 10
22 to 12
24VRTN to 9
24VRTN to 11
245