Honeywell HC900 User And Installation Manual page 250
Process and safety controller
Hide thumbs
Also See for HC900:
- Reference manual (456 pages) ,
- Installation and user manual (264 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
16 Point DC Digital Output
Step
2
Mount RTP to DIN rail.
Latch to rail. See page 253.
Connect cable to RTP
3
Set/verify jumper positions as shown.
Module Removal / Insertion Under Power (RIUP) is supported by turning off Switch SW1 to allow removal of
the module from the rack without causing an arc. See page 83.
ATTENTION: SW1 only disconnects the positive terminal, not both sides of the DC power.
See page 240 for RTP internal schematic.
236
HC900 Process & Safety Controller User and Installation Manual
Action
Jumper open
Jumper closed
Revision 6
21 April 2017
Advertisement
Table of Contents
