Table of Contents
Advertisement
Chapter 9
Upgrading Your Server
This chapter describes the internal optional devices available for the server, the procedures for the installation or
removal of such optional devices, and notes on using them.
IMPORTANT:
Optional devices described in this chapter may be installed or removed by any user.
However, the manufacturer does not assume any liability for damage to optional devices
or the server or malfunctions of the server resulted from any installation by the user. We
recommend you ask your service representative to proceed with the installation or
removal of any optional devices.
Make sure to use only optional devices and cables authorized by the manufacturer.
Repair of the server due to malfunctions, failures, or damage resulting from the
installation of inappropriate devices or cables will be charged.
When you made any changes to the hardware configuration, make sure to update the
system (see Chapter 5 for details.).
SAFETY NOTES
Observe the following notes to install or remove optional devices safely and properly.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injuries. See the
pages 1-3 to 1-8 for details.
Do not disassemble, repair, or alter the server.
Do not look into the optical disc drive.
Do not remove the lithium, and/or the NiMH battery.
Disconnect the power plug before working with the server.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injuries, or property damage.
See pages 1-3 to 1-8 for details.
Do not lift the server only by a single person.
Make sure to complete the board installation.
Do not install the server in the rack without its cover.
Do not pinch your fingers with mechanical component.
Be aware that some components or parts of the server may be very hot.
Put a connector cover on an unused connector.
WARNING
CAUTION
9-1
Advertisement
Table of Contents
