Lan Connector Leds - NEC NovaScale R480 E1 User Manual

LAN Connector LEDs

The three LAN ports (connectors) on the rear panel feature the following LEDs.
Rear view
LINK/ACT LED
The LINK/ACT LED indicates the state of each network port normally equipped with the server. If power is
supplied to the server and the hub and they are correctly connected with each other, the LED is lit in green
(LINK state). If information is transmitted through a network port, the LED blinks green (ACT state).
If the LED does not light in the LINK state, check the network cable and the cable connection.
If the LED still does not light, the network (LAN) controller may be defective. Contact your service
representative.
1000/100/10 LED
The 1000/100/10 LED indicates whether the LAN1 to LAN4 ports normally equipped with the server are
operated through the 1000BASE-T, 100BASE-TX or 10BASE-T network interface.
If the LED lights amber, the network port is operated through 1000BASE-T.
If the LED lights green, the network port is operated through 100BASE-TX.
If the LED does not light, the network port is operated through 10BASE-T.
100/10 LED
The 100/10 indicates whether the management LAN port is operated through the 100BASE-TX or 10BASE-T
network interface.
If the LED lights green, the network port is operated through 100BASE-TX.
If the LED does not light, the network port is operated through 10BASE-T.
LINK/ACT LED
LAN connector 1
1000/100/10 LED
8-12
LINK/ACT LED
Management
LAN port
100/10 LED
LINK/ACT LED
LAN connector 4
1000/100/10
LED
LINK/ACT LED
LAN connector 3
1000/100/10 LED
1000/100/10 LED
LAN connector 2
LINK/ACT LED