Cisco Catalyst 2960 Software Configuration Manual page 204

Accessing the CLI of a Specific Member
Command
Step 6
show switch stack-member-number
Step 7
copy running-config startup-config
To remove provisioned information and to avoid receiving an error message, remove the specified switch
from the stack before you use the no form of this command.
This example shows how to provision a switch with a stack member number of 2 for the stack. The show
running-config command output shows the interfaces associated with the provisioned switch:
Switch(config)# switch 2 provision switch PID
Switch(config)# end
Switch# show running-config | include switch 2
!
interface GigabitEthernet2/0/1
!
interface GigabitEthernet2/0/2
!
interface GigabitEthernet2/0/3
<output truncated>
Changing the Stack Membership
If you remove powered-on members but do not want to partition the stack:
Step 1 Power off the newly created stacks.
Step 2 Reconnect them to the original stack through their stack ports.
Step 3 Power on the switches.
Accessing the CLI of a Specific Member
This task is only for debugging purposes, and is only available from the master.
Note
You can access all or specific members by using the remote command {all | stack-member-number}
privileged EXEC command. The stack member number range is 1 to 4.
You can access specific members by using the session stack-member-number privileged EXEC
command. The member number is appended to the system prompt. For example, the prompt for
member 2 is
session on the master. Only the show and debug commands are available on a specific member.
For more information, see the
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
7-22
Purpose
Verify the status of the provisioned switch. For stack-member-number,
enter the same number as in Step 2.
(Optional) Save your entries in the configuration file.
, and system prompt for the master is
Switch-2#
"Using Interface Configuration Mode" section on page
Chapter 7 Managing Switch Stacks
. Enter exit to return to the CLI
Switch#
12-16.
OL-26520-01