Assigning Stack Member Information - Cisco Catalyst 2960 Software Configuration Manual

Configuring the Switch Stack
This example shows how to configure the persistent MAC address feature for a 7-minute time delay and
to verify the configuration:
Switch(config)# stack-mac persistent timer 7
WARNING: The stack continues to use the base MAC of the old Master
WARNING: as the stack MAC after a master switchover until the MAC
WARNING: persistency timer expires. During this time the Network
WARNING: Administrators must make sure that the old stack-mac does
WARNING: not appear elsewhere in this network domain. If it does,
WARNING: user traffic may be blackholed.
Switch(config)# end
Switch# show switch
Switch/Stack Mac Address : 0016.4727.a900
Mac persistency wait time: 7 mins
Switch#
----------------------------------------------------------
*1

Assigning Stack Member Information

•
•
•
Assigning a Member Number
This task is available only from the master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a member number to a member. This
procedure is optional.
Command
Step 1 configure terminal
Step 2
switch current-stack-member-number
renumber new-stack-member-number
Step 3
end
Step 4
reload slot stack-member-number
Step 5 show switch
Step 6 copy running-config startup-config
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
7-20
Role Mac Address
Master 0016.4727.a900
Assigning a Member Number, page 7-20
Setting the Member Priority Value, page 7-21
Provisioning a New Member for a Stack, page 7-21
H/W Current
Priority Version
1 0
(optional)
(optional)
(optional)
Purpose
Enter global configuration mode.
Specify the current member number and the new member number for the
member. The range is 1 to 4.
You can display the current member number by using the show switch
user EXEC command.
Return to privileged EXEC mode.
Reset the stack member.
Verify the stack member number.
Save your entries in the configuration file.
Chapter 7 Managing Switch Stacks
State
Ready
OL-26520-01