Cisco Catalyst 2960 Software Configuration Manual page 210

Understanding the SDM Templates
Note
• QoS—The QoS template maximizes system resources for quality of service (QoS) access control
entries (ACEs).
Table 8-1
Resource
Unicast MAC addresses
IPv4 IGMP groups
IPv4 unicast routes
Directly connected hosts
•
• Indirect routes
IPv6 multicast groups
Directly connected IPv6 addresses
Indirect IPv6 unicast routes
IPv4 policy-based routing aces
IPv4 MAC QoS ACEs
IPv4 MAC security ACEs
IPv6 policy-based routing aces
IPv6 QoS ACEs
IPv6 security ACEs
Table 8-2
Resource
Unicast MAC addresses
IPv4 IGMP groups and multicast routes
IPv4 unicast routes
Directly connected hosts
•
Indirect routes
•
IPv6 multicast groups
Directly connected IPv6 addresses
Indirect IPv6 unicast routes
IPv4 policy-based routing aces
IPv4 MAC QoS ACEs
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
8-2
The lanbase-routing template is supported only on Catalyst 2960 and 2960-S switches running
Cisco IOS Release 12.2(55)SE or later andonly with the LAN base image.
Approximate Feature Resources Allowed on 2960-S Switch Templates
Approximate Feature Resources Allowed on Catalyst 2960-C Fast Ethernet Switch
Templates
Chapter 8
LAN base
Default routing
8K 4 K
256 256
256 .75 K
.75 K
16
0
0
0
0
384 128
384 384
0
0
128 0
Default QoS
8 K 8 K
.25 K .25 K
0 0
0 0
0 0
0 0
0 0
0 0
0 0
.125 K .375 K
Configuring SDM Templates
LAN base
Dual routing
8 K 4 K
.25 K .25 K
0 4.25 K
0 4 K
0 ,25 K
.375 K 0
0 0
0 0
0 0
.125 K .125 K
OL-26520-01