Configuring Ethernet Interfaces; Default Ethernet Interface Configuration - Cisco Catalyst 2960 Software Configuration Manual

Hide thumbs Also See for Catalyst 2960:
Table of Contents

Advertisement

Configuring Ethernet Interfaces

Table 12-3
Command
boot tftp:/file-url ...
copy tftp:/source-file-url
filesystem:/destination-file-
url
1. ARP = Address Resolution Protocol.
Configuring Ethernet Interfaces

Default Ethernet Interface Configuration

Table 12-4
listed in the table, see
see
Table 12-4
Feature
Allowed VLAN range
Default VLAN (for access ports)
Native VLAN (for IEEE 802.1Q
trunks)
802.1p priority-tagged traffic
VLAN trunking
Port enable state
Port description
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
12-26
Boot Loader Commands (continued)
Configuring a Power Management Mode on a PoE Port, page 12-33
Budgeting Power for Devices Connected to a PoE Port, page 12-34
Configuring Power Policing, page 12-36
Configuring Catalyst PoE and PoE Pass-Through Ports on Compact Switches, page 12-37
Adding a Description for an Interface, page 12-39
shows the Ethernet interface default configuration. For more details on the VLAN parameters
Chapter 13, "Configuring VLANs."
Chapter 23, "Configuring Port-Based Traffic Control."
Default Layer 2 Ethernet Interface Configuration
Description
Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.
Default Setting
VLANs 1 to 4094.
VLAN 1.
VLAN 1.
Drop all packets tagged with VLAN 0.
Switchport mode dynamic auto (supports DTP).
All ports are enabled.
None defined.
Chapter 12
Configuring Interface Characteristics
For details on controlling traffic to the port,
OL-26520-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 2960-s

Table of Contents