Gpio; Gpi; Gpo - Sony XCG-C30 Technical Manual

GPIO

GPI

The signal level which is input in the 2nd, 3rd, and 4th
DC IN connector can be detected. After selecting a
connector by LineSelector register, the signal level is
acquired from LineStatus register.

GPO

Various signals can be output from the 3rd and 4th DC
IN connector. After selecting a connector by
LineSelector register and setting LineMode to Output,
LineSource is set. The output polarity is set by
LineInverter register.
Register Parameter
LineSelector Line1 (0)
Line2 (1)
Line3 (2)
LineMode Input (0)
Output (1)
LineInverter Off (0)
On (1)
LineStatus
LineSource TriggerThrough (0)
ExposureActive (2)
StrobeActive (3)
SensorReadout (4)
UserOutput1 (5)
UserOutput2 (6)
UserOutput3 (7)
SignalTrue (8)
SignalFalse (9)
PWM (10)
Setting example:
The strobe control signal is output to GPO2 (DC IN
connector 3rd pin) by Hi active setting.
LineSelector = 1
LineMode = 1
LineInverter = 0
LineSource = 3
Setting
DC IN connector 2nd pin
DC IN connector 3rd pin
DC IN connector 4th pin
Set to output
Input setting
Without output inversion
With output inversion
Input signal level
Trigger through signal
Exposure signal
Strobe control signal
Sensor readout signal
User definition 1
User definition 2
User definition 3
Level H
Level L
Pulse generation signal
33
GPIO