Heatilator CRAVE4836-B Installation And Appliance Setup page 56

Four Square and Illusion Decorative Front
Overlap Fit (0-1 Inch Thick Finishing Material Only)
Non-Combustible Finish Materials
Decorative Front
Four Square/Illusion
WARNING! Risk of Fire! DO NOT cover rectangular
holes on bottom access panel when installing overlap
fronts.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specified in
this manual. Overlapping materials could ignite.
NOTICE: This one inch maximum not only includes the
decorative finish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
finish material.
The non-combustible finishing material, 0-1 inch thick,
should be installed up to the fireplace opening on the top
and sides.
Use the factory-installed top finishing guard to ensure the
finishing material does not extend into the fireplace open-
ing.
Non-combustible finishing material should be installed
on the bottom up to the bottom finishing template. See
Figure 10.9. Do not cover the eight rectangular holes on
the bottom access panel. See Figure 10.10 for minimum
finished opening dimensions.
Figure 10.9 Non-Combustible Finish Material Diagram for 0-1 Inch Thick Overlap Fit Method (Four Square/Illusion)
Heatilator • CRAVE4836/ST-B, CRAVE6048/ST-B, CRAVE7260/ST-B, CRAVE8472/ST-B Installation Manual • 2301-973 Rev. H • 5/17
56
Finishing Method Material Thickness
Overlap Fit
BOTTOM FINISHING TEMPLATE
= RECTANGULAR ACCESS HOLES
DO NOT COVER
0-1 inch Not included
WARNING! Risk of Fire! DO NOT apply finishing mate-
rial beyond the top finishing guard and the bottom finish-
ing template. Appliance will overheat if finishing material
extends into appliance opening.
1. Follow instructions provided with decorative front for
installation.
NOTICE: Decorative front will not fit properly if finishing
material is applied beyond the finishing guard.
BOTTOM PANEL
Trim Ring