Heatilator CRAVE4836-B Installation And Appliance Setup page 54

Clean Face Trim Front (CFT)
Inside Fit (1-4 Inches Thick Finishing Method)
Non-Combustible Finish Materials
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specified in
this manual. Overlapping materials could ignite.
Note: When a Clean Face Trim decorative front is
installed, the rectangular holes in bottom access panel
will be covered.
NOTICE: This four inch maximum not only includes the
decorative finish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
finish material.
There are two options for this method of finishing:
CFT Finishing Method
Inside Fit
Without Decorative Trim Ring: (Option #1)
Note: You will not use the trim ring, which is shipped with
the CFT front, for this application.
1. Remove bottom finishing template from bottom access
panel. Verify that factory-installed finishing guards are
installed to ensure finishing material does not extend
into the fireplace opening. See Figure 10.3.
2. The non-combustible finish material, 1-4 inches thick,
should be installed up to the fireplace opening on all
four sides, including the bottom access panel, cover-
ing the eight rectangular holes. Refer to Figure 10.4.
WARNING! Risk of Fire! DO NOT apply finishing mate-
rial beyond the finishing guard. Appliance will overheat if
finishing material extends into appliance opening.
NOTICE: Decorative front will not fit properly if finishing
material is applied beyond the finishing guard.
3. Follow Inside Fit section of the instructions provided
with decorative front.
WARNING! Risk of Fire!
• If a Clean Face Trim (CFT) front has been installed and
is to be replaced with a Four Square or Illusion decorative
front, the finishing material MUST be removed to reveal
the eight rectangular holes on the bottom access panel.
• Over-heating and fire could occur.
Heatilator • CRAVE4836/ST-B, CRAVE6048/ST-B, CRAVE7260/ST-B, CRAVE8472/ST-B Installation Manual • 2301-973 Rev. H • 5/17
54
Trim Ring
Included & Not Used
(Option #1)
Included & Used
(Option #2)
With Decorative Trim Ring: (Option #2)
The trim ring, which is included with the CFT front, will be
installed and used as a finishing template. It will be left
exposed.
1. Remove finishing template from bottom access panel.
2. Remove top and bottom finishing guards.
3. Install trim ring (included with CFT decorative front).
Push trim ring completely into the opening.
4. Place trim ring into position and install the four shoul-
der bolts through the trim ring as shown in Figure 10.6.
Install the screw as shown in Figure 10.5.
Finishing materials may be installed up to the trim ring
but must not extend beyond it. See Figure 10.7.
NOTICE: It is recommended that high temperature silicone
sealant (500º F minimum continuous exposure rating) be
used to adhere the trim ring to the finishing material.
WARNING! Risk of Fire! DO NOT apply finishing mate-
rial beyond the trim ring. Appliance will overheat if finish-
ing material extends into appliance opening.
Figure 10.5. Install Trim Ring
SHOULDER
BOLTS (4)
BOTTOM PANEL
BOTTOM GLASS SHIELD
RECTANGULAR HOLE
Figure 10.6. Install Shoulder Bolts