Furuno CI-88 Installation Manual page 16

2. MOUNTING
3. Attach the waterproofing cap (MJ-10C, supplied as the installation materials) to the
CONT port at the back of the monitor unit.
4. Using four tapping screws (5x20), fasten the fixing metal attached at step 2 to the
mounting location.
Control unit
The following optional kit is necessary.
Type: OP06-18
Name Type
Fixing metal 06-021-2101
Tapping screw 5x20
Hex. bolt M4x12
1. Cut out a hole in the mounting location referring to the outline drawings at the back of
this manual.
2. Fasten two hex. bolts (M4x12) to fix the fixing metal to the control unit.
3. Fasten four tapping screws (5x20) to fix the control unit to the mounting location.
2-6
Hex. bolts
Fixing metal
Monitor unit, rear view
Code No.: 006-556-320
Code No.
100-279-731
000-802-840
000-882-040
CONT port
Qty Remarks
1
4
2
Hex. bolt
Fixing metal