Furuno CI-88 Installation Manual page 15

Flush mounting
See the outline drawing at the back of this manual.
Monitor unit/control unit
The optional flush mount kit OP06-16 is required.
Type: OP06-16
Name
Fixing metal
Tapping screw
Hex. bolt
1. Cut out hole in mounting location referring to the outline drawings at the back of this
manual.
2. Fasten the fixing metal to the monitor and control units with four hex. bolts (M4x12).
3. Attach the waterproofing cap (MJ-A10C, supplied as installation materials) to the CONT
port at the back of the monitor unit.
4. Using four tapping screws (5x20), fasten the fixing metal attached at step 2 to the
mounting location.
Monitor unit
For flush mounting of the monitor unit, the following optional kit is required.
Type: OP06-17
Name
Fixing metal
Tapping screw
Hex. bolt
1. Cut out a hole (H207xW287) in the mounting location referring to the outline drawings at
the back of this manual.
2. Fasten the fixing metal to the monitor unit with four hex. bolts (M4x12).
Code No.: 006-556-300
Type
06-021-1311
5x20
M4x12
Monitor unit/control unit, rear view
Code No.: 006-556-310
Type
06-021-1321 100-279-622
5x20 000-802-840
M4x12 000-882-040
Code No.
100-279-611
000-802-840
000-882-040
Hex bolts
Fixing metal
Code No.
2. MOUNTING
Qty Remarks
1
6
4
CONT port
Qty Remarks
1
4
4
2-5