Removing And Replacing The Stand_Transflash Assembly - Motorola A780 Service Manual

Disassembly

Removing and Replacing the Stand_TransFlash Assembly

30
1. Remove the battery cover, battery, SIM card, stylus rear housing, and
transceiver board assembly as described in the procedures.
2. Disengage the metal clip securing the Stand_TransFlash assembly to the
transceiver board assembly.
3. Use the disassembly tool to carefully pry the flex connector from its mating
connector on the transceiver board (see Figure 14).
Stand_TransFlash
Figure 14. Removing the Stand_TransFlash Assembly
4. To replace, insert the flex connector squarely into its mating connector on the
transceiver board and press firmly until it snaps into place.
5. Position the stand_TransFlash assembly over the top end of the transceiver
board and snap the metal clip onto the top of the transceiver board.
6. Replace the transceiver board, rear housing, stylus SIM card, battery, and
battery cover as described in the procedures.
September 20, 2004
Metal Clip Location
Flex Connector
A780
6809488A90