Table of Contents
Advertisement
Figure 5. Back Panel Features
1. The probe connector in the back panel is used for the temperature
controller probe.
2. The stirrer power is provided for the stirring motor.
3. The power cord
4. A drain valve is provided for ease of removing the fluid media from the
bath. Always use a container of adequate size to hold the FULL LOAD of
fluid. Some oils are more easily drained at higher temperatures. (See
caution note in next section.)
5. The serial number is located on the upper right corner of the back panel.
The series is also stamped on this panel. When consulting with an
Authorized Service Center, use the model number and the serial number.
6. If the bath is supplied with a serial RS-232 interface, the interface cable is
attached to the back of the bath at the connector labeled "Serial Port".
7. If the bath is supplied with a GPIB IEEE-488 interface, the interface cable
is attached to the back of the bath at the connector labeled "IEEE".
8. The mains out of range indicator is on (red) when the line voltage is low.
See the Warnings in the Safety Information section for details.
Calibration Bath
Parts and Controls
back_panel.eps
23
Advertisement
Table of Contents
