Table of Contents
Advertisement
6050H
User's Guide
Back Panel
The back panel has six standard features and two optional features (see
Figure 4):
The back panel of the bath contains the following features (see Figure 5):
the bath power cord
the stirring motor power socket
the internal fuses
the probe socket
the RS-232 interface connector (optional)
the IEEE-488 interface connector (optional)
the drain tube
The drain tube is for factory use only.
1. The bath power cord extends from the back of the bath. It provides power for
2. The stirring motor power cord plugs into the socket labelled "STIRRER".
3. The system and heater fuses are internal. Never replace a fuse with one of a
4. The control probe plugs into the bath at the socket on the back of the bath
5. If the bath is supplied with a serial RS-232 interface, the interface cable is
6. If the bath is supplied with a GPIB IEEE-488 interface, the interface cable is
7. The drain is for factory use only, but must be tightly sealed when the bath is
22
the bath temperature controller, the heaters, and the stirring motor. The cord
is plugged into an AC mains socket of 230 VAC (±10 %), 10 A, 50/60 Hz.
Power to the stirring motor is switched on by the POWER switch on the
control panel.
rating greater than that specified. The heater fuses protect against shorted
heaters.
labelled "PROBE".
attached to the back of the bath at the connector labelled "RS-232".
attached to the back of the bath at the connector labelled "IEEE-488".
in use.
WWarning
Advertisement
Table of Contents
